Ring-type test structures [15] have also been reported, but their underlying www.selleckchem.com/products/Axitinib.html fundamental principles are very complicated and they are difficult to fabricate. A viable test method ��must be usable at the wafer level in a manufacturing environment, require only readily available test equipment, and it should be supported with documented structure-design, selleckchem Cabozantinib data-acquisition and data-analysis methods, and calibrated models for quantitative interpretation of results�� [9]. Out of the known methods, the best candidate for meeting the aforementioned requirements was judged to be the measurement of the electric-circuit behavior of the microstructures subjected to electrostatic loads.

Compared to the prior art correlated with complicated or even empirical manipulation of numerical means, this paper builds simple and valid approximate analytical models of the CMOS-MEMS test-keys for extracting mechanical properties.

These properties, such as Young��s modulus, and mean stress, are investigated, through the external electrical Inhibitors,Modulators,Libraries circuit behavior of the CMOS-MEMS test-keys.2.?Electromechanical Inhibitors,Modulators,Libraries Behavior of the CMOS-MEMS Bridge Test-keyA conceptual diagram of a micro bridge is shown in Figure 1. The beam is of length L, width b, thickness h, and is separated from the ground by an initial gap g. As actuated by a constant drive voltage V, the electrostatic force causes a position-dependent deflection w(x). The following assumptions are made to simulate the bridge:The bridge is homogeneous and with uniform cross section.

The bridge is within Inhibitors,Modulators,Libraries the Euler-Bernoulli model.The stress gradient is neglected.

Small Inhibitors,Modulators,Libraries deflection and ideal fixed boundary Inhibitors,Modulators,Libraries conditions.Figure 1.Schematic of the micro fixed-fixed beam.2.1. Energy ExpressionThe mechanical strain energy of an infinitesimal beam element is:dUm=��0[12(dwdx)2]d��+E[12z2(?d2wdx2)2]d��(2)The total mechanical strain energy of the beam, as shown in Figure 1, Inhibitors,Modulators,Libraries can be expressed as:Um=��0L��0[12(dwdx)2]hbdx+��0LEI[12(?d2wdx2)2]dx=��0L[��0bh2(dwdx)2+EI2(d2wdx2)2]dx(3)where b, E, h, I, L, and w represent the beam width, Young��s modulus, thickness, area inertia moment of beam cross section, beam length, and deflection, respectively.

In the integrand of Equation (3), the first term is the strain energy induced by initial stress (��0) and the second term is Inhibitors,Modulators,Libraries the bending strain energy induced by external loads.

The fringing fields are considerable and Brefeldin_A must be taken into account when modeling the electrostatic loads. For an infinitesimal beam element with length dx, the differential capacitance dC is given as [36]:dC=?[(bg?w)?1.06+3.31(hg?w)0.23+0.73(bh)0.23]dx(4)where Inhibitors,Modulators,Libraries �� and g represent the permittivity of dielectric medium and the initial gap between test beam and ground plane, respectively. Tipifarnib myeloid Hence, the total Anacetrapib electrical potential energy Ue is given by:Ue=?��0L12?V2[(bg?w)?1.06+3.31(hg?w)0.23+0.73(bh)0.23]dx(5)where Ganetespib OSA V is the applied bias voltage.