In most cases, the surfaces matched with the top of the corresponding stratigraphic unit recorded by the well completion reports, and there are only several small areas where Cabozantinib the reliability of the surfaces is questionable (Section 4.4). In a deep sedimentary basin, the number of stratigraphic units can be substantial. The database for this study was arranged with regards to stratigraphic names rather than lithological descriptions. This was done both because of the model extent and for hydrogeological purposes, as this model forms part of the large GAB system. In this current

3D geological model, there are 19 stratigraphic units, of which eight are part of the Galilee Basin, and 10 belong to the Eromanga Basin. Due to the complex nature of the basement that cannot be adequately resolved based on the available data, the basement has been combined as an undifferentiated basement layer. Due to the low density of well logs within the model domain (124 wells in an area of 61,275 km2), it is

not possible to build a 3D geological model exclusively based on well logs. To overcome this limitation, control points or “dummy points” (Pawlowsky et al., 1993) were added for each stratigraphic unit as required. In order to base the creation of control points on a realistic geological understanding, Enzalutamide order 23 cross sections (planes) were constructed. These cross sections were designed in an orthogonal network and perpendicular to the major geological structures known in the area, similar to the procedure described by Royse (2010). In each cross section, a new curve was digitised for each stratigraphic unit, using the loaded input data as constraints and incorporating geological knowledge. Following this, the curves for each stratigraphic unit were grouped together for the development of bounding surfaces (i.e. formation tops). In

each cross section, well logs and seismic surfaces were loaded Loperamide and a digitalisation process was carried out, which assessed the distribution of each stratigraphic unit from the base (Basement) to the top (Mackunda-Winton formations), as well as the distribution of the main structures. In addition to the creation of control points from the 23 cross sections, these sections were also used to constrain regional faults. In this case, control points were created on opposite sides of faults highlighting the displacement observed in the seismic surfaces. In order to generate the 3D geological model, it is only necessary to develop a surface for the top of each stratigraphic unit, as the base of each unit is represented by the top of the underlying unit (e.g. Raiber et al., 2012). Once all the dummy points were created, stratigraphic surfaces were developed from the formation picks (where formation tops were intersected in wells) and the additional control points derived from the cross-sections using GoCAD’s Discrete Smooth Interpolation (DSI) algorithm.